Case Studies

→ Resources

Case Studies

→ Resources

HydraTite Internal Pipe Joint Seals are used to eliminate leaks by sealing pipes from the inside. These seals can restore nearly any structurally sound, man-entry-sized pipe that has a point defect.

A technician sitting a pipe that has been sealed with the HydraTite seal

HydraTite installed over a joint in a large corrugated pipe to eliminate leaks

A box culvert that has been sealed with a HydraTite seal, installed over a corner form

A HydraTite seal installed over a joint in a corrugate pipe

A joint in an ADS pipe that has been sealed with HydraTite the internal pipe joint seal

Two people pushing apart a pipe

HydraWrap the Structural Composite Repair System is used to rehabilitate aging pipes by wrapping them in carbon fiber fabric and epoxy.

HydraWrap applied to the exterior of a partially unearthed pipe

A reducing elbow pipe at a waste water facility wrapped in HydraWrap

A technician applying a HydraWrap to the exterior of a vertical digester mixing pipe

A portion of cast-iron pipe restored with HydraWrap

A portion of a FRP pipe wrapped in HydraWrap to restore the pipe

A tee and elbow pipe wrapped with HydraWrap, restoring this segment of pipe

Contact Us Today To Learn More About Our Products

HydraLock repairs deteriorating pipes from the INSIDE with no excavation. Great for emergency repairs in small-diameter pipes.

A packer installing HydraLock in a small-diameter pipe

An exposed joint in a pipe

A mechanical packer inside a pipe being used to install HydraLock over a connection point

Marine HydraWrap an all-inclusive kit with carbon fiber fabric and epoxy that offers a rapid repair. This system ABS Design approved and is designed for offshore use.

An old elbow pipe that has been restored by HydraWrap

A portion of a heavy fuel oil line that has been wrapped in carbon fiber fabric, HydraWrap

A 4-inch pipe wrapped in HydraWrap to restore the seawater piping

An elbow pipe that has been wrapped with HydraWrap to protect and strengthen it

Portions of a cooling water supply pipeline that have been wrapped in HydraWrap

A portion of pipe repaired with HydraWrap

With an emphasis on chemical and corrosion resistance, HydraLine’s epoxy-based products have proven effective as primers, fillers, FRP binders, and chemical and corrosion resistant coatings.

Epoxy applied to the interior of an expansion joint

The fiber glass liner was cracked on the base of this stormwater retention tank

An active leak in a riser at a hydroelectric power

A technician working inside an expansion joint

The base of a stormwater retention tank coated in epoxy

A portion of a riser that has had its surface ground clean

Loading index…

Full Case Study Catalog

HydraTite

10-Foot Seals Installed At A Pump Station

13ft Diameter Reinforced Concrete Water Pipe

31 Seals In Two Days

36-Inch Corrugated Polyethylene Outfall Pipe

42-Inch Waste Water Pipe

48-Inch Circulating Water Line

60-Inch Concrete Pipe Joints

66″ Culvert Repair Under NY Thruway

A Century-Old Pipeline Restored With HydraTite

Addressing High Head Pressure

Alleviating Multiple Points Of Concern

An Air Supply Line With Compromised Joints

An Emergency Repair For A Power Plant

Aqueduct Leaking On To Highway & Its Traffic

Box Culvert Repair

Box Seals Installed In A Coal Conveyor Tunnel

Box-Shaped Flume Repair

Brand New Leaking Pipe

Bridging Offset Joints

Bringing New Life To Aging Twin Culverts

Circulating Water Expansion Joint Repairs

Clearing Out Tuberculation & Installing 29 Seals

Cooling Water Piping Corrosion

Corrugated Metal Pipe Experiencing Infiltration

Cracked 42″ Diameter Gravity Drain

Culvert Rehabilitation

Custom Seals Installed Underwater

Debris Infiltration in Storm Drain

Demonstrating HydraTite & Preventing Future Sinkholes

Deteriorated Expansion Joint Repair

Deteriorated Joints in Outfall Pipe

Divers Installing HydraTite

DOT Storm Drain

Eliminating Leaks & Preventing More From Forming

Ensuring Bison Continue To Receive Water

Extending The Service Life Of A 186″ Pipe

Exterior Leaking in a Recirculating Cooling Line

External Crack to Expansion Joints

Failing Ductile Iron Pipe Joint

Failing Joints In An RCP Stormwater Drainage System

Frozen Storm Sewer Repair

Groundwater Inflow Infiltration

Guarding A Transition Against Infiltration

Helping Prevent An Interstate From Collapsing

Installing All Over The County

Installing Box Seals To Rehabilitate A Storm Drain Sump

Installing During A Limited Window Of Shutdown

Installing HydraTite Around A Limestone Conveyor

Installing HydraTite In A Vertical Pipe

Installing HydraTite On A DOT Project

Installing HydraTite Seals In An Elliptical Tunnel

Installing Nine Irregularly-Shaped Seals

Installing Over Active Leaks

Installing Three Seals In A New Pipe

Interlocking Three Seals To Eliminate A Leak

Keeping A Power Plant Running

Locating and Sealing Deep Pipeline Leaks with Precision

Massive Box Seal Installed Over A Failing Expansion Joint

New 36-Inch Sewer Line

Newly Installed Leaking Ductile Iron Pipe

Our Fastest Installation Yet

Overseeing A Seal Installation

Power Plant Substation

Preparing Pipes For Service

Preventing Further Separation

Protecting A Municipality’s Water Supply

Providing A Permanent Fix For Storm Drain Leaks

Providing An Additional Layer Of Protection

Providing Peace Of Mind

Rapid Joint Rehabilitation Without Traffic Disruption

Rehabilitating Defective Joints In An Elliptical Pipe

Reestablishing Proper Flow In Five Culverts

Rehabilitating 24″ Pipe With Separation At The Joints

Rehabilitating Nearly Every Joint In Two Culverts

Removing Deposits From Pipe Interior To Ensure A Proper Seal

Repairing A Recirculating Pump Line

Repairing A Water Main On A Tight Schedule

Repairing Drainage Pipes Under A Levee

Repairing Sanitary Pipe That Had A 6 Inch Hole

Repairing Two Joints In A 13-Foot Siphon

Restoring Pipe, Inside And Out

Restoring Raw Water Line Integrity With Internal Pipe Joint Seals

Restoring Structural Integrity After Seismic Damage

Sanitary Sewer Experiencing Wall Loss

Sealing 189 Joints In Three Box Culverts

Sealing A Complex Transition Joint in Remote Mountain Location

Sealing A D-Shaped Drinking Water Pipe

Sealing A Dam Overflow Pipe

Sealing A High-Pressure Water Main Joint In Arkansas

Sealing Critical Pipe Transitions to Stop Infiltration

Sealing Every Joint In A Pipeline

Sealing Every Joint In These Culverts

Sealing Over Cracks In A Box Culvert

Sealing Over Tears In HDPE Pipes

Sealing Stormwater Tanks For A Dublin Data Center

Sealing The Joints Between New Pipe And An Existing 84″ Water Main

Sealing Three Sides Of Large Tanks

Sediment Pond Sinkhole

Separated Culvert Joints Under A Busy State Route

Separated Joints In A Corrugated Metal Pipe

Severe Joint Separation

Six Joints In A 60-Inch Water Main

Stabilizing Roadway Drainage with HydraTite

Stopping Contaminants From Entering The Pipe

Stopping Infiltration At A Power Plant

Storm Drain Infiltration

Submerged Square Culvert

Ten Seals Installed In Three Days

Terminating A Cured-In-Place Liner

Through Wall Leaks

Twenty Seals Installed In Twin Culverts

Two Box Seals Installed In Vertically Stacked Box Flumes

Two Days To Install Twenty-Two Seals

Water Treatment Facility Leak

Water Main Blocking And Sealing

Water Main Installation, Seven HydraTite Seals

Working In A Sanitary Sewer

Working In Tight Quarters

HydraWrap

Applying Carbon Fiber To A 12” Diameter Pipe

Circulating Water Cooling Tower Deterioration

Condenser Water Boxes Structural Repair

Cooling Tower Tunnel Repair

Cooling Water Piping Corrosion

Cooling Water Piping Through Wall Leaks

Corroded High Pressure Gas Line

Defective Welds In A Hydroelectric Dam’s Water System

Hydraulic Jumps

Hydroelectric Dam

Midwestern HydroElectric Plant

Pavilion Post Repair

Reducing Elbow Repair

Rehabilitating 24″ Pipe With Separation At The Joints

Rehabilitating A 36″ Surge Vessel

Rehabilitating A Long Section Of Pipe

Rehabilitating Four Risers In A Cooling Water System

Rehabilitation Of Ash Sluice Pump Intake Manifolds

Reinforcing Clamps On A Sanitary Pipe

Reinforcing Welds To Comply With ASME Design Codes

Repairing A 90″ Soil-To-Air Interface & Preventing Further Corrosion

Restoring Integrity to 10-Inch Cast Iron Pipe

Restoring Two Vertical Digester Pipes

Revitalizing Wooden Supports

Severe Joint Separation

Stopping Multiple Leaks at a Power Plant

Wrapping 12 Feet Of A Cast Iron Pipe

Wrapping An 18 Inch Pipe At A Pump Station

Marine HydraWrap

Condensate Pipe Leak

Cooling Water Supply Pipe Leaks

Elbow Pipe Repair

Fuel Oil Line Leak

Installation On A Ferry On The East Coast of US

Leaking Suction Pipe

Repairing A Tee Fitting In A Lube Oil System

Repairing Two Tee Fittings

HydraLock

Preparing Pipes For Service

Sealing Existing PVC To New FRP Base Liner

HydraLine

Circulating Water Expansion Joint Repairs

Rehabilitating Four Risers In A Cooling Water System

Waterproofing Repair

10448 Chester Road, Cincinnati, OH 45215

Privacy Policy • Terms & Conditions

© 2026